Gun Emplacement Mk. II 8
After many hours sanding, filling, spraying, filling, sanding etc the modified gun mounting plate was ready for casting.
I removed the plate I had previously added to the gun mounting plate so that the area where the crew raise and lower the gun was free of trip hazards (health & safety...), the hole underneath along with the circular hole at the rear had then to be filled and sanded flat (too ages and many goings over). The modified Basilisk plate was then added before going round filling in, sanding and so on...
Anyway. I did a mould and knocked out some casts...
 |
| The first perfect cast. |
 |
| As you can see two of the three had an imperfection on the edge. Bloody annoying. |
I drilled out the two holes where the Earthshaker pieces fit into and assembled the Earthshaker. Blu-tac only for now:
And then in the fully raised position...
 |
| 'Bang Bang' said Militiaman Bob as he smugly looked over the wall. |
Sort of tempted to actually paint it...long shot but it may happen.
Next up...
Scatter Terrain 10
The Dragons Toof got a mould done and I knocked a few casts out.
I did a few in plaster and a few in resin to see the difference in them.
Rather than just take some pictures of some casts I based four of them (two plaster and two resin) and added some sand. Keep in mind this was a very quick and rough basing job, just wanted to see how the parts looked in context.
 |
| Militiaman Bob gets around. |
 |
| Undercoated you can't tell the difference between the two materials. |
Shock, horror I actually painted them - again just a quick and rough job.
I went with a brass top plate just to highlight them, I doubt I would go with brass eventually.
The plan is to do a few casts in resin incorporating rebar, i'll carve them up and add damage etc before using them as master for a set of moulds.
Quite pleased how they turned out, was a bit worried if the skulls would show up well enough originally but they show up easily without being too in your face.
0 Yorumlar